B) Alarm Release - Conrad CE 100 Bedienungsanleitung

Setting the temperature limit
If „Hi" flashes in the display, the upper temperature limit for all tyres can be set with the buttons DOWN / ON/OFF (2)
or UP (4).
Resetting to factory settings
• Keep the button DOWN / ON/OFF (2) pushed until a beep sounds and the display unit goes off.
• Keep the button DOWN / ON/OFF (2) pushed until a beep sounds and the display unit comes on.
• Push the button SET (3) at once after activation and keep it pushed until the button SET (3) lights up red and a beep
sounds.
• All values have now been reset to the factory settings listed below:
Pressure unit
Upper air pressure threshold
Lower air pressure threshold
Temperature unit
Temperature threshold
Encoding of the sensors is not reset by this.

b) Alarm Release

The sensors send the air pressure and temperature values to the display unit at intervals of five minutes. The following
happens if a measured value is outside of the set thresholds:
• A warning sound is triggered.
• The SET (3) button flashes red.
• The corresponding symbols for the tyre position, the alarm type (tyre pressure or temperature) and the measured
value flash in the display.
If the pressure escapes from a tyre very quickly due to a defect, the air pressure alarm will sound at once.
Push any key to deactivate the warning sound. The button SET (3) and the icons in the display continue to flash until
the measured values are in the permissible range again.
28
PSI
44 PSI (3.0 BAR)
29 PSI (2.0 BAR)
°C
70 °C (158 °F)