Operation; Setting The Parameters - Conrad CE 100 Bedienungsanleitung

9. Operation

Inattentiveness on the road may cause serious accidents. Operation of the tyre pressure control
system therefore is only permitted when the traffic situation permits and you are not distracted
from traffic by operation.
a) Setting the Parameters
• Continue to keep the SET button (3) pushed until a beep sounds.
• Push the SET (3) button again until the desired parameter is displayed.
• Push the buttons DOWN / ON/OFF (2) or UP (4) to change the selected parameter.
• Push the SET (3) button again to start selecting and adjusting other parameters.
• After making the settings, push the button SET (3) until a beep sounds. The changes are now saved.
If you do not push any button for one minute, the device will switch back to regular operation made without
saving the settings.
Setting the pressure unit
If „PSI" or „BAR" flashes in the display, the pressure unit can be set with the buttons DOWN / ON/OFF (2) or UP (4).
Setting the temperature unit
If „°C" or „°F" flashes in the display, the temperature unit can be set with the buttons DOWN / ON/OFF (2) or UP (4).
Setting of the upper air pressure threshold for the front tyres
If „Hi" and the two icons for the front tyres flash in the display, the upper air pressure threshold van be set with the
buttons DOWN / ON/OFF (2) or UP (4).
26