RockShox Boxxer Ride Benutzerhandbuch Seite 8

E
NGLISH
THAN EIGHT SPACERS CAN CAUSE THE SPRING TO BE DAMAGED
,
PRELOAD YOU MAY NEED TO INSTALL SOFTER OR FIRMER COIL SPRINGS
To change the preload:
1. Remove the top caps with a 24mm six-point socket wrench.
2. Inspect the O-rings for damage and replace if necessary.
3. Slightly compress the fork to get access to the preload spacers, which sit on top of the spring stacks.
4. Add or remove preload spacers and/or springs as necessary.
5. Re-install top caps and torque to 55 to 75 in-lb.
External Rebound Adjustment
Rebound damping controls the speed at which a fork returns to its full extension
following compression. Located at the bottom of the right fork leg is the rebound
adjuster. Using the 2.5mm hex key that came with your fork, turn the adjuster in the
direction indicated by the rebound speed decal. The adjuster has a 90-degree range of
adjustment. Turning the adjuster toward the "rabbit" decreases rebound damping,
causing the fork to return to full extension faster. Turning the adjuster in the direction
indicated by the "turtle" increases rebound damping, slowing the return of the fork to
full extension.
N :
OTE THIS ADJUSTER IS
Excessive rebound damping will cause the fork to "pack up" over successive bumps ,
reducing travel and causing the fork to bottom out. Set your fork to rebound as fast as
possible without "topping out" or kicking back. This allows your fork to follow the
contours of the trail, maximizing sta b i l i t y, traction and control.
N : T
OTE HE HEX KEY MAY BE USED ON BOTH REBOUND AND COMPRESSION DAMPING ADJUSTMENTS
- - ,
THE TRAIL USE THE HEX KEY MAY BE STORED BY CAREFULLY SLIDING IT IN BETWEEN THE UPPER TUBE AND
.
RUBBER FORK STOP
External Low Speed Compression Adjustment (World Cup
and Team)
Low speed compression damping controls pedal bob, brake dive and
f o r k s e n s i t i v i t y. The adjuster is located in the lower left leg and is
accessible with a 2.5mm hex key inserted through the hollow shaft b o l t .
The adjuster has eight full turns of adjustment. Clockwise rotation of the
adjuster results in more low speed compression damping. Compression
damping should be adjusted any time the springs or preload have been
changed. Proper compression damping depends on rider style, weight,
preference and fork setup.
N : T
OTE HIS ADJUSTER IS
Internal High Speed Compression Adjustment (World Cup
and Team)
This adjuster controls high speed compression blow-off while leaving your
low speed compression adjustment virtually unchanged. The high speed
compression adjuster is located inside the left l e g . To adjust the high speed
compression you must follow instructions available in the Boxxer Service
Guide available on our website at www.rockshox.com. With the assembly removed, use a
5mm wrench, turn the compression nut clockwise to increase high speed compression
damping and counterclockwise to decrease high speed compression damping (Fig. 1).
Note the location of the low speed adjuster prior to making the high speed adjustment.
C : E
AUTION NSURE THE END OF THE COMPRESSION ADJUSTER ROD DOES NOT BECOME RECESSED INTO THE
. T
NUT HE NUT MAY BECOME DISENGAGED DURING OPERATION IF THE ADJUSTER IS NOT FULLY THREADED INTO
.
THE NUT
8
NOT .
INDEXED
NOT .
INDEXED
SRAM C • B
ORPORATION
. I
F YOU CAN NOT ACHIEVE THE PROPER
.
95.4309.223.000, R
U M
OXXER SER ANUAL
. F -
OR ON
High Speed
Compression
Adjuster Nut
Fig. 1
. C
EV