Beurer BM 35 Gebrauchsanweisung Seite 17

Insert the cuff tubing into the socket
for the cuff attachment.
Important: The instrument should only be operated with the
original cuff. The cuff is suitable for an arm circumference of
22 to 36 cm.
A larger cuff for upper arm circumferences from 30 to 42 cm is
available from retailers or the service address under order no.
162.973.
Correct posture
• Rest for approx. 5 minutes before each measurement. Other-
wise there may be divergences.
• You can perform the measurement either sitting or lying down.
Always make sure that the cuff is on a level with your heart.
• To carry out a blood pressure measurement, make sure you
are sitting comfortably with your arms and back leaning on
something. Do not cross your legs. Place your feet flat on the
ground.
• In order not to distort the result, it is important to keep still
during the measurement and not talk.
Select memory
Switch on the blood pressure monitor with the
Select the required memory space by pressing the function key
+. You have two memories (60 memory spaces each) in order
to save the test results of 2 different people separately, or else
save measurements in the morning and evening separately.
Measuring blood pressure
• Put on the cuff as described previously and assume the posi-
tion in which you want to carry out the measurement.
• Using the buttons +, select the user memory 1 or 2. Start the
measurement process by pressing ON/OFF button
checking the display with all digits lighting up, the monitor
will automatically inflate. Following the self-test, during which
all display elements briefly appear, the measurement begins.
During inflation the device already determines measured val-
ues used to estimate the required inflation pressure. If this
pressure is insufficient, the device automatically inflates by
another.
• Then the pressure in the cuff is slowly released and the pulse
is measured.
• When the measurement has been completed, the remaining
air pressure is released very quickly. The pulse, the systolic
and the diastolic blood pressure are displayed.
• You can interrupt measurement at any time by pressing the
ON/OFF button .
• The _ icon appears if it has not been possible to perform
the measurement properly. Observe the section in these
instructions on error messages/troubleshooting and repeat
the measurement.
• The device switches off automatically after 1 minute.
17
button.
. After