Measurements; Error Message / Troubleshooting - Beurer BC 30 Gebrauchsanweisung

Blood pressure Systole
value category (in mmHg)
Setting 3:
severe hyper- ≥ 180
tension
Setting 2:
moderate hyper- 160 – 179 100 – 109
tension
Setting 1:
mild hyperten- 140 – 159 90 – 99
sion
High normal 130 – 139 85 – 89
Normal 120 – 129 80 – 84
Optimal < 120
Source: WHO, 1999 (World Health Organization)

6. Measurements

Save
• The results of every successful measurement are stored
together with the date and time. There are 3 user memo-
ries each with 40 memory spaces. If there are more than
40 measurements, the oldest measurements are lost.
Display
• Select the desired user memory (
pressing the function button SET.
• Press the memory button M. The average value of the last
three measurements is displayed first
Diastole
Action
(in mmHg)
seek medical
≥ 110
attention
seek medical
attention
regular monitoring
by doctor
regular monitoring
by doctor
self-monitoring
< 80 self-monitoring
, or ) by
.
• If you continue to press the memory button M, the most
recent individual measured values are displayed in turn with
the date and time.
Delete
• To clear the memory of the relevant user memory, you must
first select a user memory. Start a request for either aver-
age values or individual measured values and press the set-
ting button MODE and the function button SET at the same
time.
• All the values in the current user memory are deleted.
appears on the display.
The device switches off automatically after 1 minute.

7. Error message / troubleshooting

In the event of errors, the error message
display.
Error messages may appear in the following cases:
• : the cuff is incorrectly fastened, or you move or speak
during the measurement,
• : errors during measuring,
• : the pump pressure is higher than 300 mmHg,
• : errors in the recorded measurement data,
• : there is a system or unit error.
In such cases, repeat the measurement. Ensure that you do
not move or speak.
If necessary, reinsert or replace the batteries.
20
appears on the