Transportation And Handling; Installation; Operation; Filling - Quick MILL Evolution '70 Bedienungsanleitung

Mod. Evolution '70 push-buttons
The operator must not:

Touch hot surface areas, only using the controls
provided;

Perform maintenance operations or transport the
machine with the plug inserted or when the
machine is hot;

Remove the plug by pulling on the power cable;

Use the machine if the power cable shows damage;

Touch the machine with wet or damp hands or
feet;

Turn over or lay the machine and packaging on its
side.

Clean the machine using a direct spray or water
under pressure, or with steam;

Immerse the machine in water or any other type of
liquid;

Lean liquid containers against the machine.

The machine is not intended for use by persons
(including children) with reduced physical, sensory
or mental abilities, except in the case where they
have received assistance or training in the use of
the equipment by a person who is responsible for
their safety. Adopt the precautions necessary so
that children cannot touch the equipment.
Whenever the machine appears to wet or
overly damp,
installation and use until it can be
determined that the machine has completely dried.
In any event, it is necessary to have the service centre
perform an inspection to ascertain if any damage has
occurred to the electrical components.
Precautions for use
The machine is to be operated only for its intended use
and not for any other purpose, such as the grinding and
delivery of products which are not coffee or non-food
products.

7. TRANSPORTATION AND HANDLING

During transport, always keep the package in the
correct position referring to the indications printed on
the outside of the box.
Do not turn over or lay the machine and packaging on
its side.
The packaging contains loose parts and accompanying
documentation which is to be kept for further
consultation.

Open the upper part of the package, remove the
accessories and then slip the machine from the
wrapper.

Check the integrity of the machine, the accessories,
the power supply cable and plug, and in the event
of damage contact the retailer immediately.
do not proceed with
The packaging
polystyrene, nails, cardboard, etc.) must not
be left within the reach of children as they
are a potential sources of danger. Send
packaging material to an authorised waste disposal
company.

8. INSTALLATION

The machine is shipped ready for installation in
accordance with the data found rating plate.
Ensure that the machine specifications comply with
those of the local electrical power supply.
The electrical system must be equipped with an
efficient residual current device or an automatic circuit
breaker with an efficient earthing system. In the event
no electrical safety device is present, have a qualified
technician install a two pole rocker switch/thermal-
magnetic circuit breaker as required by current safety
regulations.
Proper earthing of the device is mandatory.
The manufacturer declines all responsibility
in the event this health and safety
regulation is not respected.
Be careful not to damage the power supply cable by
bending, crushing or stresses.
Do not disconnect the power supply to the
machine by pulling on the cable. Disconnect
by handling the plug.
It is advised to avoid positioning the machine in tight
spaces or avoid disruption to its operation, supply or
maintenance.

The surface where the machine is to be installed
must be level, dry, durable and stable, and at a
height of at least 80 cm from ground;

Position the machine and connect the power
supply cable to the electrical socket.

9. OPERATION

9.1. Filling

Fill the water reservoir with water, softened, drinking
water if possible. Insert the reservoir, making sure that
the rubber dip tube is not crimped or bent.

9.2. Switching on

Set the general switch to position 1 to power the
machine. The push-button LED lights switch ON, in
sequence, for 4 seconds then switch OFF.
P L E A S E N O T E : f o r t h e m o d e l s
br e w i n g c o f f e e , m a k e s u r e t h a t
o n a n t i - c l o c k w i s e )
When the machine is used for the first time,
let approximately 0.5 litres of water flow
Rev.05
material (plastic bags,
w i t h o n e t h e r m o b l o c k , be f o r e
t h e s t e a m w a n d c l o s e d i s ( t u r n i t