Auto Setup (Ypao) - Yamaha RX-V1065 Bedienungsanleitung

USB
Problem
The music files and
The music files and folders are stored the
folder cannot be locations other than the FAT area.
browsed.
You are attempting to browse directory
hierarchies of over 8 levels or a directory
with more than 500 files.
This unit cannot recognize some
characters used in the file name or folder
name.
The USB storage The USB storage device is not compatible
device cannot be with mass storage class (except USB
recognized.
HDDs).
This unit does not recognize the USB
storage device properly.
Status message
USB Connected
Your USB storage device is connected.
Disconnected Your USB storage device has been
disconnected from the USB port of this
unit.
This unit recognizes the USB storage
device as an illegal device.
Access Error This unit cannot access your USB storage
device.
There is a problem with the signal path
from your USB storage device to this unit.
Unable to play The data is invalid.

Auto Setup (YPAO)

Notes
• If the an error or warning message appears, resolve the problem and then run "Auto Setup" again.
• Warning message "W-2" or "W-3" indicates that the adjusted settings may not be optimal.
• Depending on the speakers, warning message "W-1" may appears even if the speaker connections are correct.
• If error message "E-10" occurs repeatedly, contact a qualified Yamaha service center.
Before Auto Setup
Error message
Connect MIC! Optimizer microphone is not connected.
Unplug HP!
Headphones are connected.
Memory Guard! The parameters of this unit are protected.
Cause
Place the music files and folders in the FAT area.
Modify the data structure on your USB storage
device.
Edit the file name or folder name using a PC and then
try again.
Use a USB storage device that is compatible with
mass storage class (except USB HDDs).
Turn this unit off and then turn on again.
Cause
Check the connection between this unit and your
USB storage device.
Turn this unit off and then turn on again.
Try another USB storage device.
Turn off this unit and reconnect your USB storage
device to the USB port of this unit.
Try resetting your USB storage device.
Try another USB storage device.
Cause
Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
Unplug the headphones.
Set "Memory Guard" to "Off".
Troubleshooting
Remedy
Remedy
Remedy
See
page
—
—
—
—
19
See
page
—
—
19
—
18, 19
—
—
See
page
20
—
52
65
En