Yamaha RX-V1065 Bedienungsanleitung Seite 67

Remote control
Problem
The remote control Wrong distance or angle.
does not work or
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, strobe
light, etc.) is striking the remote control
sensor of this unit.
The batteries are weak.
The remote control ID of the remote
control and this unit do not match.
The remote control code is not correctly
set.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
The remote control The batteries of remote control of this unit
does not learn new
(or the external component) are weak.
functions.
The distance between the two remote
controls is too long or too short.
The signal coding or modulation of the
other remote control is not compatible
with this remote control.
Memory capacity is full.
iPod™
Note
• In case of a transmission error without a status message appearing on the front panel display and GUI screen, check the connection of your iPod
(page 17).
Status message
Loading... This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
Cause
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees
offaxis from the front panel.
Adjust the lighting angle or reposition this unit.
Replace all batteries.
Match the remote control ID of this unit and the
remote control.
Set the remote control code correctly using "List of
remote control codes" at the end of this manual.
Try setting another code of the same manufacturer
using "List of remote control codes" at the end of this
manual.
If this unit does not work when you press jCursor,
do the following.
When the key does not work during DVD disc menu
operation: press the dInput selection keys on
the remote control again.
When the key does not work during Option menu or
Setup menu operation: press the key applicable for
the current menu operation again.
Replace the batteries
Place the remote controls at a proper distance.
Learning is not possible.
Delete unnecessary functions to free some memory
space for the new functions.
Cause
Troubleshooting
Remedy
Remedy
See
page
9
—
9
57
55
55
—
9
56
—
56
See
page
63
En