Connecting A Usb Storage Device; Using The Video Aux Jacks; Connecting The Fm And Am Antennas; Assembling The Am Loop Antenna - Yamaha RX-V1065 Bedienungsanleitung

Connections

Connecting a USB storage device

Connect a USB memory device or USB portable audio
player to the USB port on the front panel of this unit. For
information about USB storage devices supported by this
unit, see page 37.
EMORY l PRESET h FM AM
SCENE
BD/DVD TV CD RADIO
INPUT
STRAIGHT PURE DIRECT
EFFECT

Using the VIDEO AUX jacks

Use the VIDEO AUX jacks on the front panel to connect a
game console or a video camera to this unit. Be sure to
turn down the volume of this unit and other components
before making connections.
l h
EMORY PRESET FM AM
SCENE
BD/DVD TV CD RADIO
INPUT
STRAIGHT PURE DIRECT
EFFECT
VIDEO
V
Game console or video
camera
18
En
VOLUME
l TUNING h
VIDEO AUX USB
OPTIMIZER MIC
VIDEO AUDIO
USB
USB memory device or
USB portable audio player
VOLUME
l h
TUNING
VIDEO AUX USB
OPTIMIZER MIC
VIDEO AUDIO
L AUDIO
R
L R

Connecting the FM and AM antennas

An indoor FM antenna and an AM loop antenna are
supplied with this unit. Connect these antennas properly to
the respective jacks.
Indoor FM antenna
Outdoor AM antenna
Connect a 5 to 10 m (16 to
33 ft) vinyl-covered wire,
and extend it outdoors
(use the AM loop antenna
together with this
antenna).
DOCK
PHONO
S VIDEO
COMPONENT
VIDEO
P
R
GND
P
B
VIDEO
Y
Ground (GND terminal)
The GND terminal is not for earth grounding.
To reduce noises, connect a ground bar or a
vinyl-covered wire with a copper plate at its tip,
and place it in the moist ground.
y
• The supplied antennas are normally sensitive enough to obtain good
reception.
• Position the AM loop antenna away from this unit.
• If you cannot get good reception, we recommend that you use an outdoor
antenna. For details, consult the nearest authorized Yamaha dealer or
service center.
• Always use the AM loop antenna even when the outdoor antenna is
connected.

Assembling the AM loop antenna

Connecting the AM loop antenna

The wires of the AM loop antenna have no polarity. You
can connect either wire to the AM terminal and the other
to the GND terminal.
Press and hold
AM loop
antenna
HDMI OUT HDMI 1 HDMI 2 HDM
(BD/DVD)
ANTENNA MONITOR OUT
COMPONENT
UNBAL.
VIDEO
GND AM
FM
REMOTE
P
R IN
OUT
P VIDEO
B
Y
12V
0.1A MAX.
TRIGGER OUT
Insert Release