Sharp FD03EB Bedienungsanleitung Seite 7

STEP 2: Adjust the seatpost
a. Release the seatpost quick release.
b. Adjust the seatpost height and saddle angle to fi nd your most
comfortable riding position, please be careful not to exceed the
minimum safety scale line.
c. Tighten the quick release.
STEP 3: Install the pedals
Use the 15 mm wrench to mount the pedals, as shown in fi gure.
L R
NOTES:
Pedal thread must be lubricated before being assembled.
Check the end cap on both pedals to identify the left pedal and right pedal.
Please note that the right pedal will tighten clockwise, while the left pedal will
tighten anticlockwise. Make sure the torque is about 35 N·m.
How to use the E-bike
Fully charge the battery before fi rst use.
Check tire pressure regularly for best performance.
How to charge
a. Open the rubber cap and plug the charger into the e-bike charge port
or take the battery off and charge it. Make sure that the charger port is
in the given direction.
b. Plug the charger into the mains wall socket.
c. When connected to the battery charger, the battery will start to charge
and the charge indicator on the charger will turn red.
d. After the charging is complete, the charge indicator will turn green.
Remove the battery charger when fully charged.
e. Close the rubber cap after charging.
charge indicator
NOTES:
The red switch on the battery serves to turn the power on and off . It should
be used when the bike is not in use to disconnect the battery and protect
it from unwanted discharge or damage. USB port can function as a power
bank for charging external devices with a maximum current of 0.5 A.
The Assisted Pedalling
This electric bicycle is equipped with an "assisted pedalling system",
consisting of a motor, a battery and a speed sensor.
It is important to know that when the system is on, the engine undertakes
to supply energy only while you are pedalling. When you stop pedalling,
the motor switches off and the electrical assistance for pedalling is missing.
In all pedal-assisted bicycles the engine switches off and the electrical
assistance stops when the maximum speed allowed for electric bicycles of
25 km/h is reached.
When the speed drops below this value, the electrical assistance starts
again until you stop pedalling.
How to start an E-bike
Before starting up for the fi rst time, make sure the red switch is in the
ON position
EN