Care And Maintenance; General Safety Instructions - Jarolift Basic Originalmontageanleitung

Cleaning procedure
CAUTION - Risk of injury!
Disconnect the external Venetian blind if it
can be operated outside your field of vision.
• Use cleaning products that are suitable for the surfaces
!
• Remove dust or dirt (e.g., dead leaves) from the side
channels!
• Perform a complete functional check: observe the external Veneti-
an blind throughout its entire range of motion to ensure that it is
functioning properly.

General safety instructions

The following instructions protect your health and ensure the
longevity of the product. Please read all instructions carefully.
Damage caused by misuse or failure to follow these instruc-
tions is not covered by the warranty.
Domondo accepts no liability for consequential damage.
Follow the assembly steps and instructions carefully:
■
improper use can result in injury and/or property damage.
■
Only assemble the product if it is in perfect technical
condition.
■
Before assembly, check the load capacity of the mounting
bracket.
■
Cordon off the assembly area to ensure the safety of those
around you.
■
Choking hazard!Plastic film, polystyrene parts, small parts,
etc., can be dangerous for children if they are handled as
toys. Never leave packaging materials lying around. Keep
children away from small parts and packaging.
■
Risk of electric shock if installed incorrectly! The fixed
installation of electrically operated Venetian blinds must
be carried out by a licensed electrician in accordance
with VDE 0100. Follow the instructions supplied with the
electrical device.
■
Risk of damage to the product in the event of a power
failure!An electrically operated external Venetian blind
cannot be retracted without a power supply. In windy
areas where power failures are frequent, it is recommen-
To ensure a long service life, we recom-
mend that you clean the surface of the
external Venetian blind regularly.

CARE AND MAINTENANCE

Maintenance procedure
CAUTION - Risk of injury!
Never use a Venetian blind that requires repair. Un-
plug the blind before performing any maintenance.
• Regularly check that the control elements show no visible
signs of wear or damage and that the blind is stabl
• Have damaged parts replaced or repaired in good time by a
specialist company.
• Only use original spare parts to ensure the proper functioning
and safety of the blind.
ded that a backup power supply be provided to protect
the blind and ensure its operation.
■
Risk of crushing and injury! The area where the product
moves must remain free of any obstacles, whether fixed or
mobile. When raising or lowering the blind, never touch
the moving parts (e.g., the load bar) and do not pull on
the Venetian blind except to operate it using its control
system.
■
Risk of material damage When raising or lowering the
blind, never exceed the mechanical limit of the Venetian
blind.Observing this limit will prevent damage to the
mechanism and ensure a long product life.
■
Danger of death!Installation in front of emergency exits or
emergency doors is strictly prohibited. Follow this instruc-
tion to ensure the safety of occupants and allow for rapid
evacuation in case of emergency.
■
Danger of death if the Venetian blind falls!De installateur
is verantwoordelijk voor de juiste keuze van het beves-
tigingsmateriaal en het naleven van de instructies van
de fabrikant. Het gebruikte bevestigingsmateriaal moet
geschikt zijn voor de ondergrond.Houd u aan het voorge-
schreven aantal bevestigingen voor de geleiders om de
veiligheid en stabiliteit van de zonwering te garanderen.
■
Risk of injury – Unsupervised or improper use Never allow
the Venetian blind to be used improperly or without
supervision.nstall the control element outside the blind's
movement area, but within the field of vision.Comply with
national regulations for disabled persons to ensure safety
and accessibility.
We recommend that you perform
maintenance at regular intervals or
have it performed by a specialist
company.
17 17