Residual Risks; Operation; Switching On/Off; Attaching/Removing Sanding Sheet - Parkside IAN 280260 Originalbetriebsanleitung

Sanding dust in the dust sack, micro
filter, paper sack (or in the filter sack or
extraction system filter) can self-ignite
under unfavourable conditions such
as flying sparks caused by grinding
metals. Particular hazards are caused
if the sanding dust is mixed with paint,
polyurethane residues or other chemi-
cal substances, or if the sanded object
is hot after long working periods.
Please check the operating manual of
your vacuum cleaner whether it is suit-
able for the suction of grinding chips.
• Connect the appliance to a power
socket with a residual current circuit
breaker of rated residual current no
more than 30 mA.
• If the supply cord of this power
tool is damaged, it must be re-
placed by a specially prepared
cord available through the ser-
vice organization.

RESIDUAL RISKS

Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn;
b) Cuts
c) Ear damage if working without ear pro-
tection.
d) Eye damage if suitable eye protection
is not worn.
e) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.

Operation

Switching on/off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type plate.
Connect the machine to the power
supply.
1. To switch on, flick the on/off
switch (1) to position
will power on.
2. To switch off, flick the on/off
switch (1) to position
tool will power off.
Attaching/removing
sanding sheet
Clean the sanding disc before you
attach a sanding sheet.
When using sanding sheets without
ventilation holes, dust extraction is
not possible.
Use only appropriate sanding sheet
sizes. Sanding sheets, which ex-
tend beyond the sanding disc, can
cause injuries and can cause the
sanding sheets to block or tear.
The sanding plate (10) is fitted with Velcro for
rapid attachment of the sanding sheet (12).
Attaching sanding sheet
1. Press the sanding sheet (12)
evenly onto the sanding plate
(10). Ensure that the holes in the
sanding sheet (12) are placed
above the openings in the sand-
ing plate (10).
G B
„I". The tool
„0". The
9