Cleaning Of The Dispenser; Cleaning/Removing Of The Filter - Pkm WA6-E1008N Bedienungsanleitung

5.1 Cleaning of the dispenser

1. Press the lever in the main-wash compartment and remove the dispenser (fig.
A).
2. Remove the cover grid of the softener compartment. Remove the separator of
the main-wash compartment (pull, fig. B).
3. Clean all parts under running water.
4. Install the separator and cover grid and insert the dispenser into its recess.

5.2 Cleaning/removing of the filter

 We strongly recommend to clean the filter regularly (at least twice or thrice a
year).
 You have to clean the filter if the appliance does not drain the water properly or
does not run the spinning programme.
 You have to clean the filter if the pump is blocked by any foreign object (e.g.
buttons, coins etc.).
1. Switch off the appliance is disconnect it from the mains.
2. Depending on model:
a. Insert a flathead screwdriver into the small opening of the bottom cover
panel. Press the cover panel using a lot of force - but also being careful -
downwards. remove the cover panel.
b. Push the two laterally-mounted pressure points ("noses") downwards.
Remove the cover panel.
3. Place a container in front of the opening.
4. Open the filter, but do not remove it completely. Rotate the filter in anti-
clockwise direction until the water begins to run.
5. Wait until the water has drained completely.
6. Unscrew the filter completely and remove it.
7. Clean the filter and filter recess.
61