Installation; Unpacking/Site; Removing Of The Shipping Bolts - Pkm WA6-E1008N Bedienungsanleitung

2. Installation

WARNING! Remove the safety bolts before initial use (see chapter
2.2); otherwise the appliance may cause serious injury to persons and/or
severe damage to the appliance.
Important information: The installation of this appliance must be carried out by
a person who is experienced in such a work
intended for such a person. The manufacturer is not liable for any damage caused
by improper installation.

2.1 Unpacking/Site

1. Unpack the appliance carefully. Dispose of the packaging as described in
chapter waste management.
2. Install the appliance in a suitable position with an adequate distance from
sources of heat and cold.
3. Check that the appliance and the power cord are not damaged.
4. Install the appliance in a dry and well-ventilated place. The room temperature
must be higher than 0
5. Do not install the appliance on a carpet/fitted carpet.
6. Protect the appliance from direct sunlight.
7. Do not install the appliance in a bathroom or a place where it may come in
contact with water or rain; otherwise the insulation of the electrical system will
be damaged. Do not install the appliance in a room where explosive or
flammable gases are stored.
8. Install the appliance on a level, dry and solid floor. Check the correct
installation with a bubble level.
9. Connect the appliance to the mains properly.
10. All required installations for the electric and water supply must be carried out
by a qualified professional.
11. The nameplate is situated at the back of the appliance.

2.2 Removing of the shipping bolts

3 Not included in guarantee.
0 C.
.
42
3 . The following instructions are