Kärcher KMR 1700 D Bedienungsanleitung Seite 31

Front sealing strips
Start the motor.
Raise the waste container up to the
end-position.
Switch off engine.
Lock parking brake.
Use the safety bar for emptying from a
height.
Unscrew the sealing strips.
Fold the new sealing strips and fasten
them with screws and fastening tracks.
Sealing strips of the waste container
Replace sealing strips.
Remove the safety bar.
Start the motor.
Lower the waste container up to the
end-position.
Switch off engine.
Lock parking brake.
Changing the headlight bulb
Unscrew the head lamps.
Take out the head lamps and pull out
the plug.
Note: Note the positions of the plugs.
Dismantle the head lamps.
Dismantle the head lamp casing and
hold it horizontally because the lamp
unit is not fastened.
Unlock the bracked and take out the
bulb.
Insert new bulb.
Reinstall in reverse sequence.
Replace the bulbs of the direction-indi-
cator lamp
Note: Remove the glass of the direction-in-
dicator lamp from its casing to replace the
bulb.
Replacing fuses
Open rear engine panel
Unfold the fuse box and open it.
1 Spare fuses
2 Description of the fuses
Replace defective fuses.
Note: Only use fuses with identical safety
ratings.
Lubricate the bearings and cylinder
– Tilting cylinder
13
-
EN
– Lifting cylinder and pusher rod
Use a grease press to lubricate the lu-
bricating nipple at the bearings.
Place a film of grease on the cylinder
surfaces.
31