Kärcher KMR 1700 D Bedienungsanleitung Seite 29

Loosen the screws in the bearing block
till these are loose and can be removed.
Pull out the bearing block to the maxi-
mum possible extent.
Remove the lamella filter.
Insert new filter.
Make sure driver engages with holes on
drive side.
Push in the bearing block and tighten
the screws.
Remove the safety bar.
Start the motor.
Lower the waste container up to the
end-position.
Switch off engine.
Close the dust filter cover.
Replacing side brush
Start the motor.
Raise the waste container up to the
end-position.
Switch off engine.
Lock parking brake.
Use the safety bar for emptying from a
height.
Tilt the side-brushes outwards.
Unscrew the side-brush.
Fix in the new wiper blade.
Tilt the side-brush inwards.
Remove the safety bar.
Start the motor.
Lower the waste container up to the
end-position.
Switch off engine.
Lock parking brake.
Change the air filter
The air filter is to be changed if the indicator
shows red.
Open engine cover.
Press together the hood lock at the air
filter casing.
Remove the hood.
Remove the dirty filter.
Insert new filter.
Replace hood on the air filter casing.
Note:Pay attention to correct position (let-
tering) on the hood. You must hear the
hood locking in.
11
-
EN
To reset the indicator press the key on
the floor of the indicator.
Close the engine cover.
Check and adjust the V-Belt
The V-Belt must loosen up approx. 7-9 mm
in the centre between the crankshaft and
the light machine at a pressure of 10 kg.
Adjust the V-Belt tension by adjusting
the light machine.
Clean and replace fuel filter
Danger
Risk of explosion!
– Do not carry out maintenance tasks in
closed rooms.
– Smoking and naked flames are strictly
prohibited.
Switch off engine.
Close the fuel supply.
Loosen the ring screw and remove the
fuel filter along with the contents.
29