Preparing The Measurement - Beurer BM 55 Gebrauchsanweisung

• Windows 7
• Windows 7 SP1
• Windows 8
• Windows 10
2. Supported architectures:
• x86 (32 Bit)
• x64 (64 Bit)
3. Hardware requirements:
• Recommended: At least Pentium 1 GHz or faster
with at least 1 GB RAM
• Free memory on the primary partition of at least:
– x86 – 600 MB
– x64 – 1.5 GB
• Display resolution from: 1024 x 768 pixels
• USB port 1.0 or later

4. Preparing the measurement

Inserting the batteries
• Remove the battery compart-
ment lid on the rear of the
device.
• Insert four 1.5 V AAA (alkaline
type LR03) batteries. Make
sure that the batteries are
inserted the correct way round.
Do not use rechargeable bat-
teries.
• Close the battery compartment
lid again carefully.
All display elements are briefly displayed,
display. Set the date and time as described below.
If the battery replacement symbol
played, you can no longer perform any measurements and
must replace all batteries. Once the batteries have been
removed from the device, the date and time must be set again.
Any saved measurements are retained.
Battery disposal
• The empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to
dispose of the batteries.
• The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
Setting the hour format, date and time
This menu allows you to set the following functions, one after
another.
Hour format
It is essential to set the date and time. Otherwise, you will not
be able to save your measured values correctly with a date and
time and access them again later.
If you press and hold the M1 or M2 memory button, you
4 x 1,5V AAA (LR03)
can set the values more quickly.
23
is permanently dis-
Date Time
➔ ➔
flashes in the