Intended Use - Dover Vsg Rav.535 .196200 Serie Betriebs- Und Wartungsanleitung

2.4 Intended use

The product is intended for raising vehicles in accordance with the applicable regulation, Machinery Directive 2006/42/
EC; the lifting capacity is indicated on the serial number plate.
The lift has been designed for indoor use where it is protected from the effect of the wind.
It may be used to raise vehicles that meet the following requirements:
For transversal distance values lower or higher than the described range, or for longitudinal
distance values lower than the minimum value, the capacity
of the lift is decreased. Therefore, in such cases, or any others not covered by this manual,
please contact the Manufacturer.
Weight not exceeding the lift capacity (Tab. A) as required by UNI EN 1493:2010.
The lift conforms to the distribution of load on the support points and the conditions of reversibility set out UNI EN
1493:2010:
- 3:2 / 2:3 (reversible) (Fig. 1).
Distance between support points (Fig. 2):
Longitudinal (min.) (A) 1400 ÷ 1800 mm.
Transverse (min.) (B) 1000 ÷ 1700 mm.
- The vehicle must only be loaded using the lifting points recommended by the Manufacturer.
- When lifting, use the rubber pads supplied with the lift. Do not stack the rubber pads.
- Accessories are available for lifting special vehicles.
3
75
IMPORTANT
2
Fig. 1
A
Fig. 2
0579-M2300-0
Rev.n.0 (09/2025)
3
2
INDICE