0.3 General safety regulations
The lift may only be used by trained, authorised personnel who have read and fully under-
stood this manual. The operator must be authorised by the plant supervisor.
The lift and its safety devices may not be altered or modified nor the safety devices by-
passed in any way. If this occurs, the manufacturer shall not be liable for resulting damage.
The User must also ensure the following instructions are adhered to:
•
The installation procedure must be carried out by authorised, qualified personnel.
•
Ensure the rubber pads are properly positioned on the lift and grab the vehicle at the appropriate points under
the chassis
•
Make sure that the vehicle stops are mounted at the ends of the platforms and that they are secured correctly.
•
Make sure the vehicle handbrake is engaged.
•
Check that no hazardous conditions arise while raising and lowering the vehicle. If so, stop the lift immediately
and eliminate the cause of the emergency.
•
Before raising the vehicle, make sure that the distribution of the load on the axles corresponds to the lift
specifications.
•
After raising the vehicle, set the switch to "0".
•
Every day, before starting work, check that the audible lift descending alarm functions correctly.
•
Never attempt to raise a vehicle when there is any one sitting inside it or if there are hazardous or explosive
materials aboard.
0.4 Life Limits
A general evaluation of the residual life-time is to be done at latest 10 years of employ by a qualified technician, preferably
authorized by the manufacturer.
69
CAUTION
CAUTION
0579-M2300-0
Rev.n.0 (09/2025)
INDICE