Chap. 5 Installation Requirements; Minimum Requirements For Installation Site - Dover Vsg Rav.535 .196200 Serie Betriebs- Und Wartungsanleitung

CHAP. 5 INSTALLATION REQUIREMENTS

5.1 Minimum requirements for installation site

Check that the area where the machine is to be installed meets the following requirements:
- The lift may only be operated in closed environments, where there is no danger of explosion or fire.
- Sufficient lighting (but without glare or excessively bright lights). Reference standard EN 12464-1.
- Environment not exposed to the elements.
- Environment with adequate air change rate.
- Pollutant-free environment.
- Noise level lower than the applicable regulatory requirements (≤70 dB).
- Room temperature: min. 5°C - max. 55°C.
- Not subject to hazardous movements caused by other machines being operated in the same environment.
- Environment not used for storing explosive, corrosive and/or toxic material.
- The columns must be positioned at least 50 cm from the walls or from any fixed equipment.
- The installation layout should be planned so that the operator can see all the equipment and the surrounding area
from the operating position. The operator must prevent unauthorised persons and potentially dangerous objects
from entering this area.
All installation work involving connections to external power supplies (especially electrical
power supplies) should be performed by professionally qualified staff.
The system must be installed by authorised personnel, in accordance with any special
instructions that may be included in this booklet; in case of doubt, consult the authorised
service centres or ESR technical assistance.
SI
94
CAUTION
IMPORTANT
NO
0579-M2300-0
Rev.n.0 (09/2025)
INDICE
NO