Inhaltsverzeichnis
Werbung
Unit_Diag_Bit(87) = "Reserved"
;========================================================================
; Modul Definition
;========================================================================
Module = "Empty_Module"
1
EndModule
Module = "Massflow"
2
EndModule
Module = "Gastemp."
3
EndModule
Module = "Total"
4
EndModule
Module = "SET_Total"
5
EndModule
Module = "SET/MODE_Total"
6
EndModule
;Special iG-Feature
; Enable by removing the ';' character in front of the line
; Disable by insert ';' character in front of the line
; Warning Removing/insert the character only in the next two lines
Module = "Characteristics-Input"
7
EndModule
;Modul Assignment
; only for GSD-Rev. 3.0
; Enable by removing the ';' character in front of the line
; Disable by insert ';' character in front of the line
; Warning Removing/insert the character only in the next five lines
;SlotDefinition
;Slot(1) = " Analog Input" = 2 1,2,3
;Slot(2) = " Analog Input" = 3 1,2,3
;Slot(3) = " Totalizer"
;Slot(4) = " Characteristics-Input" = 7 1,7
;=============================================================================
; END of File
;=============================================================================
42/14-39 DE
Sensyflow iG, Intelligenter thermischer Gas-Massendurchflussmesser PROFIBUS DPV1
Anhang: Herstellerspezifische GSD-Datei (Geräte-Stamm-Datei)
0x00
0x42,0x84,0x08,0x05
0x42,0x84,0x08,0x05
0x41,0x84,0x85
0xC1,0x80,0x84,0x85
0xC1,0x81,0x84,0x85
0xA6
; Gas Characteristics 0..4 if Enabled, Total-Special-Function
= 4 1,4,5,6,7
;Empty,Massflow,Gastemp.
;Empty,Gastemp.
;Empty,Total,SET_Tot.,SET/MODE_Tot.,Character.-Input
;Empty,Character.-Input
61
Werbung
Inhaltsverzeichnis
