Inhaltsverzeichnis
Werbung
MaxTsdr_500 = 100
MaxTsdr_1.5M = 150
MaxTsdr_3M = 250
MaxTsdr_6M = 450
MaxTsdr_12M = 800
Redundancy = 0
Repeater_Ctrl_Sig = 0
24V_Pins = 0
;===================================================================
; Slave specific Data
;===================================================================
Freeze_Mode_supp
Sync_Mode_supp
Auto_Baud_supp
Set_Slave_Add_supp
Min_Slave_Intervall
;===================================================================
; Bitmap, Order No, ASIC
;===================================================================
Implementation_Type = "SPC3"
Bitmap_Device = "ABB05CAn"
Bitmap_Diag = "ABB05CAd"
Bitmap_SF = "ABB05CAs"
OrderNumber = "Automation Products" ; user defined keyword, known in COM Profibus
;===================================================================
; Ext_User_Prm_Data_Ref
;===================================================================
Max_User_Prm_Data_Len
Ext_User_Prm_Data_Const(0)
;DPV1 status1
;
;
;DPV1 status2
;
;DPV1 tatus3
;
;===========================================================================
; Module Definition
;===========================================================================
Modular_Station
Max_Module
Max_Input_Len
Max_Output_Len
+ 4 Byte real Format + 1 Byte Status
Max_Data_Len
Max_Diag_Data_Len
Slave_Family
;Gerätespezifische Diagnose Byte 1
Unit_Diag_Bit(24) = "Hardware failure"
Unit_Diag_Bit(25) = "Reserved"
Unit_Diag_Bit(26) = "Reserved"
Unit_Diag_Bit(27) = "Electromic Temp. to high"
Unit_Diag_Bit(28) = "Memory error"
Unit_Diag_Bit(29) = "Sensor failure"
Unit_Diag_Bit(30) = "Device not initialized"
Unit_Diag_Bit(31) = "Selfcalibration failed "
42/14-39 DE
Sensyflow iG, Intelligenter thermischer Gas-Massendurchflussmesser PROFIBUS DPV1
Anhang: Herstellerspezifische GSD-Datei (Geräte-Stamm-Datei)
= 1
= 1
= 1
= 1
= 50
Bit2
Bit7
Bit0
alarm not implemented
= 1
= 4
= 15
= 9
= 24
= 14
= 3
; no redundancy transmission
; no Freeze_Mode_supp, support in later version
; no Sync_Mode_supp, support in later version
; Slave Intervall-Time 5 ms
; symbolic representation in standard cases
;symbolic representation for diagnostic cases
; symbolic representation in spec. oper. modes
= 3
= 0x84,0x00,0x00; DPV1 parameters
= 0x84 =>
= 0 WD_Base=10ms (1ms=1)
= 1 DPV1 Enable (Disable = 0)
= 0x00 =>
= 0 ChkCfg nach EN50170(User specific = 1)
= 0x00 =>
; 4 x ( 4 Byte real Format + Status Byte)
; 1 Byte Gas Characteristics + 1 Byte Total. no Profile 3.0
; + 2 Byte Total
; Max_Output_Len + Max_Input_Len
; no specification
59
Werbung
Inhaltsverzeichnis
