Tenda Wi-Fi 7 Router Schnellinstallationsanleitung Seite 7

Internet Connection with NFC
The router has NFC stickers, you can connect your NFC-enabled devices to the
router's Wi-Fi with one-touch. Only NFC-enabled Android or HarmonyOS phones
or tablets can connect to the internet with one-touch.
1. Write Wi-Fi information to NFC stickers.
(1) Install and register Tenda WiFi App by scanning the QR code. After managing
the router (connect to the router's Wi-Fi, the App will automatically discover
the router), enter the router configuration page and navigate to the NFC
Sticker.
Scan to download Tenda WiFi App
(2) Select the Wi-Fi name you want to write into sticker, and tap Write NFC Sticker.
(3) Place the NFC sticker near the NFC area of the phone (usually around the
camera on the back of the phone).
Wait for a moment, the Wi-Fi information is successfully written into the NFC
sticker. Place the NFC sticker in a visible location at home for internet access.
*NFC stickers can be re-written if the Wi-Fi name or Wi-Fi password changes.
2. Connect your phone to the internet.
* Ensure that the NFC function is enabled, and the screen is unlocked and active.
Place the NFC sticker near the NFC area of the phone, wait for a moment, and
remove the phone when the phone prompts for sound or vibration. When the
phone prompts Connect to network, tap CONNECT to connect to Wi-Fi
without encryption.
03
Indicator
Indicator Scenario Status
Startup Solid green
Solid green
Blinking green slowly
Primary
node
Blinking red slowly
Blinking orange slowly
Internet
connection
Solid green
Solid orange
Secondary
Indicator Solid red
node
Blinking green slowly Waiting to connect to another node.
Blinking red slowly
WPS Blinking green quickly
Ethernet cable Blinking green quickly
connection for 3 seconds
Resetting Blinking red quickly
Jack, Ports and Buttons
The jacks, ports and buttons may vary with models. The actual product prevails.
Jack/Port/Button
Description
Used to start the WPS negotiation process, or to reset the router.
- WPS: Through the WPS negotiation, you can connect to the Wi-Fi network of the router
without entering the password.
Method: Press the button for about 1-3 seconds, and the indicator blinks green fast. Within
2 minutes, enable the WPS function of the other WPS-supported device to
establish a WPS connection.
MESH/RST
- Mesh: When it is used as a Mesh networking button, you can extend your network with
another device that supports the Mesh function.
Method: Press this button for about 1-3 seconds. The indicator blinks green fast, which
indicates the device is searching for another device to form a network. Within 2
minutes, press the MESH/WPS button of another device for 1-3 seconds to
negotiate with this device.
- Reset method: Refer to Q4 in FAQ.
1/2.5GE/2/3/4 WAN/LAN auto-adaptive port. Any Ethernet ports can be functioned as WAN or LAN port.
Power jack.
POWER
Description
The system is starting up.
The router is connected to the internet.
Not configured and the router is not connected to the internet.
Configured but the router failed to connect to the internet.
Configured but not connected to an Ethernet port.
Networking succeeds. Good connection quality.
Networking succeeds. Fair connection quality.
Networking succeeds. Poor connection quality.
Configured but the router failed to connect to the internet.
Pending for or performing WPS negotiation (valid
within 2 minutes)
A device is connected to or disconnected from an Ethernet
port of the router.
Restoring to factory settings.