Cleaning And Maintenance; In Case Of Failure - Mpm Mod-52 Bedienungsanleitung

AIR FILTER CLEANING AND REPLACEMENT
Normal use of the vacuum cleaner requires periodical replacement or cleaning of the air
filter, which protects the motor from the side of the dust bag, and the air outlet filter. For
this purpose, disconnect the appliance from the power supply and detach the suction
pipe.
1. Release the latch in the cover (10), remove the cover and then remove the filters (11), (12), (13).
2. Remove the motor filter (22). You will access the filter by lifting the cover (5) and removing the
dust bag (14). Remove the filter element (22).
3. Clean the HEPA filter element (12) of dust. The HEPA filter element must be perfectly dry be-
fore installing it again. Before closing the cover (10), make sure that the HEPA filter element is
aligned. Do not wash the HEPA filter element.
4. Wash filter cartridges (11), (13), (22) under running and cool water. Dry the filters thoroughly
after washing.
5. Cartridges should be cleaned every month or more frequently (depending on the usage). If a
cartridge is too contaminated or damaged, replace it with a new one.
6. When installing the filter elements, carefully align them in the housing and the vacuum cleaner.
CAUTION: THE FILTER CARTRIDGE BEING MOUNTED MUST BE COMPLETELY
DRY. MOUNTING A WET FILTER MAY CAUSE AN ELECTRIC SHOCK.

CLEANING AND MAINTENANCE

1. Periodically clean the vacuum cleaner housing and other external elements with a damp cloth.
This will allow maintaining good appearance of the appliance.
2. For this purpose, do not use sharp objects or any strong detergents (e.g. solvents), as this will
cause permanent damage to the vacuum cleaner housing.
3. For air filters and dust bag, follow the above instructions.

IN CASE OF FAILURE

Failure type:
front cover not thoroughly
closed
vacuum cleaner housing
overheating
low suction power
Possible causes:
dust bag not attached or
attached improperly
a slight housing temperature increase is normal, but if the
temperature increases considerably, immediately turn off the
vacuum cleaner and contact the service
strongly contaminated filters
full dust bag
blocked hose or extension pipe remove all items blocking the
Instructions:
attach the dust bag properly
clean or replace the filters
replace the dust bag or empty
the textile bag
hose or pipe
EN
27