Cleaning And Maintenance; In Case Of Failure; Technical Data - Mpm Mod-55 Bedienungsanleitung

EN
3. Clean the HEPA filter (21) of accumulated dust. If heavily soiled, you can rinse the filter in cool
water. Make sure that the HEPA filter is completely dry before inserting it.
4. Wash the sponge filters (20) and (22) in running and cool water. Dry the filters thoroughly after
washing.
5. Clean the filters every month or more frequently (depending on the frequency of use). If any of the
filters is too dirty or damaged, replace it with a new one.
6. When installing the filters, pay particular attention to the correct
CAUTION! The installed filters must be completely dry. The assembly of the wet filters
poses the risk of electric shock.

CLEANING AND MAINTENANCE

1. Clean the housing of the vacuum cleaner and the rest of its external components from time to
time with a damp cloth. This will help keep the appliance looking good. Sharp objects and all kinds
of strong cleaning agents (e.g. solvents) must not be used for this purpose, as this will permanently
damage the vacuum cleaner housing.
2. In the case of air filters and the dust bag, act in accordance with the above-mentioned hints.
3. If the appliance is not going to be used for a long time, remove the batteries from the appliance to
avoid electrolyte spillage.
CAUTION! Do not discard used batteries with your municipal waste. Only discard them
in proper pick-up points or at the store. Do not place the battery in fire. Do not combine
batteries of different types or new and used batteries.
CAUTION! Do not assembly wet filters – risk of damage to the vacuum cleaner.
CAUTION! Each time, prior to any maintenance or cleaning activities, turn off the appli-
ance and remove the plug from the socket. Do not submerge the appliance into water!
CAUTION! Do not use sharp objects, abrasive polishes, solvents or other strong chem-
icals for cleaning since their use may cause damage to the appliance.

IN CASE OF FAILURE

Type of failure:
front cover not closed properly
overheating of the vacuum
cleaner housing
low suction power

TECHNICAL DATA

Technical specifications are given on the product nameplate.
Length of mains cable: 7 m.
30
Possible causes:
the dust bag is not inserted or it
is inserted improperly
Slight heating of the housing is normal; if it gets very hot, switch
off the vacuum cleaner and contact the service centre
heavily soiled filters
filled up dust bag
clogged suction hose or
telescopic tube
Tips:
instal the dust bag properly
clean or replace the filters
replace the dust bag
remove any objects that block
the suction hose or telescopic
tube