Using The Appliance; Accessories Overview - Mpm Mod-52 Bedienungsanleitung

EN
APPLIANCE ASSEMBLY
1. Press both latches on the suction hose mounting ring (17), insert the ring into the opening (7)
and release the latches. To disassemble, press the latches again and remove the ring (17) from
the opening (7).
2. Connect the other side of the suction hose (18) to the handle (19) and connect the metal tele-
scopic wand (16) to the other side of the handle (19). Install one of the tools, (20) or (21), on the
end of the wand.

USING THE APPLIANCE

1. Before turning on the vacuum cleaner, unwind the power cord (9) to a suitable length and plug
it into the mains socket. The yellow mark on the power cord indicates the optimum length. Do
not pull out the cord beyond the red mark! While unwinding the cord, do not press the cord
winder button (23).
2. Press the switch (1) to turn on the vacuum cleaner. When at work, you can regulate the suction
power by moving the suction power control left or right to a suitable position.
NOTE! It is recommended to set the suction power control (1) to MIN before turning on
the vacuum cleaner!
WARNING! Dust bag filling level indicator light turns red when the suction hose is
clogged or the dust bag is full. You need to replace the dust bag or remove the clogging
from the suction hose.
3. To wind the power cord, press the cord winder button (23) with one hand, while holding the
cord with another hand to prevent a sudden movement that could damage it.
4. To ensure optimum appliance setting upon the completion of work, use the guide (3) in the rear
of the vacuum cleaner. Place the rail in the rear of the floor-carpet attachment with connected
suction hose and telescopic pipe on the guide. The second guide that facilitates vacuum clean-
er storage in the vertical position is under the bottom of the appliance.

ACCESSORIES OVERVIEW

FLOOR-CARPET ATTACHMENT
Designed for cleaning large flat surfaces. It is equipped with castors that facilitate move-
ment in difficult to access places and a flexible joint, connecting it with the suction hose,
which allows directing at various angles. When you press the button on the upper attach-
ment housing (switch it to the brush mode), a row of rigid bristles will appear on the bottom
to facilitate cleaning hard floors.
SLIT ATTACHMENT WITH MOVABLE BRUSH
Used for cleaning difficult to access areas, such as in room corners, by and below pieces of
furniture and in bends and slits. It is also perfect for cleaning computer keyboards, draw-
ers, radiators or window frames.
REPLACING THE DUST BAG
To replace the dust bag, disconnect the appliance from the power supply, detach the suc-
tion hose (18), press the button (6) to open the upper cover (5), slide out the dust bag, while
holding the flange with the inlet opening directed upwards. Install new dust bag. You can
purchase spare dust bags.
26