Cleaning And Maintenance - Mpm Mod-53 Bedienungsanleitung

ACCESSORIES OVERVIEW
FLOOR-CARPET ATTACHMENT
Designed for cleaning large flat surfaces. It is equipped with castors that facilitate move-
ment in difficult to access places and a flexible joint, connecting it with the suction hose,
which allows directing at various angles. When you press the button on the upper attach-
ment housing (switch it to the brush mode), a row of rigid bristles will appear on the bottom
to facilitate cleaning hard floors.
SLIT ATTACHMENT WITH MOVABLE BRUSH
Used for cleaning difficult to access areas, such as in room corners, by and below pieces of
furniture and in bends and slits. It is also perfect for cleaning computer keyboards, draw-
ers, radiators or window frames.
EMPTYING THE DUST BAG
To empty the dust bag, turn off the vacuum cleaner, disconnect it from the power source,
unhook the narrow suction hose (18), then use the button (6) to open the top cover (5) and
remove the bag with the frame. Then slide the bag out of the frame (12) and remove the
plastic seam sealing the bag above the waste bin. After emptying the bag, replace the bag's
sealing seam, insert the bag into the frame and place the frame into the dust container.
Finally, close the cover (5).
AIR FILTER CLEANING AND REPLACEMENT
Normal use of the vacuum cleaner requires periodical replacement or cleaning of the air
filter, which protects the motor from the side of the dust bag, and the air outlet filter. For
this purpose, disconnect the appliance from the power supply and detach the suction
pipe.
1. Open the cover (5), remove the dust bag (14) and then remove the motor filter grid (22). Slide
out the filter insert.
2. Remove the cover (10) and gently pull out the exhaust filter (11).
3. Remove dust from the removed filters using fine bristles. Do not immerse or wash the filters in
water or other liquids.
4. Clean the cartridges every month or more often (depending on the frequency of use). If any of
the cartridges is too dirty or damaged, replace it with a new one.
5. After cleaning, reinstall the filters, install the cover (10), close the dust bag (14) and close the
dust bag cover (5).

CLEANING AND MAINTENANCE

1. Periodically clean the vacuum cleaner housing and other external elements with a damp cloth.
This will allow maintaining good appearance of the appliance.
2. For this purpose, do not use sharp objects or any strong detergents (e.g. solvents), as this will
cause permanent damage to the vacuum cleaner housing.
3. For air filters and dust bag, follow the above instructions.
EN
27