Description Of Accessories; Cleaning And Maintenance - Mpm Mod-180 Bedienungsanleitung

EN
4. Use the guide (3) on the back of the hoover to optimally position the unit after use. Place the
rail on the back of the floor-carpet attachment with the connected suction hose and telescopic
tube on the guide. A second guide for easy upright storage of the hoover is located underneath
the unit.

DESCRIPTION OF ACCESSORIES

FLOOR AND CARPET ATTACHMENT
It is designed for cleaning large flat surfaces. It is equipped with wheels for easy movement
in hard-to-reach areas and a flexible joint connecting it to the suction hose, allowing it to
be guided at different angles. When the button on the top of the attachment is pressed
(putting it into brush mode), a row of stiff bristles will appear on the underside of the at-
tachment and allow hard floors to be cleaned.
CREVICE ATTACHMENT WITH MOVABLE BRUSH
It is used for cleaning hard-to-reach areas such as corners of rooms, around and under
furniture and in folds and crevices. It is also perfect for cleaning computer keyboards,
drawers, radiators or window frames.
CHANGING THE DUST BAG
To change the dust bag, disconnect the appliance from the power supply, unhook the suc-
tion hose (18), then open the top cover (5) using the button (6), eject the dust bag by hold-
ing the collar with the inlet opening facing upwards. Put on a new bag. It is also possible to
purchase additional paper bags for the hoover depending on your needs.
CLEANING AND REPLACING AIR FILTERS
Normal operation of the hoover requires the filter covering the motor on the dust bag
side and the filter at the air outlet to be replaced or cleaned from time to time. To do this,
disconnect the device from the power source, unplug the suction pipe.
1. Release the latch in the cover (10), remove the cover and then remove the filters (11), (12), (13).
2. Remove the motor filter (22). You can access the filter by lifting the hoover cover (5) and re-
moving the dust bag (14). Pull out the filter cartridge (22).
3. Clean the EPA filter cartridge (12) of accumulated dust. Ensure that the EPA air filter cartridge
is dry before insertion. Ensure that the EPA filter cartridge is in the correct position before
closing the lid (10). Do not wash the EPA filter.
4. Wash the filter cartridges (11), (13) and (22) in running and cool water. After washing, dry the
filters thoroughly.
5. Clean cartridges monthly or more frequently (depending on frequency of use). If one of the
cartridges is too dirty or damaged then replace it with a new one.
6. When assembling the cartridges, pay particular attention to the correct position of the car-
tridge in the filter housing and the filter in the hoover.
NOTES: THE INSTALLED FILTER ELEMENT MUST BE COMPLETELY DRY. FITTING
A WET FILTER POSES A RISK OF ELECTRIC SHOCK.

CLEANING AND MAINTENANCE

1. Clean the housing of the hoover and its other external components from time to time with a
damp cloth. This will help keep the device looking good.
28