Device Parts - Steinbach Smart Rxb 450 Kurzanleitung

SAFETY
The following signal words are used in this quick guide:
Warning!
serious injury if not avoided.
Please note!
General safety instructions
Charging at a temperature below 10 °C causes chemical damage to the cell
and can lead to a fire.
• Charge the battery at room temperature.
Improper charging and discharging can disproportionately impair the
performance of the battery.
• Fully charge the battery before using the device for the first time.
• Fully recharge the empty battery within 12 hours.
• Fully charge the battery at least once every three months, even if the
device has not been in use during this time.
• Only charge the battery when the charging socket is clean and dry to avoid
corrosion. Damage to the charging pins is not covered by the warranty.
DESCRIPTION
The battery-operated swimming pool cleaner carries out the maintenance
cleaning of your filled pool in automatic mode. The removable filter unit filters
the water and collects deposits from the pool.

DEVICE PARTS

1) Carrying handle
2) On and off button
3) Cleaning mode display
4) LED display
PREPARATION
1. Charging process
1. Switch off the device before charging.
The on/off button is located on the top of the device.
2. Open the cap of the charging socket (7).
3. Connect the charger to the device.
The charging socket is located on the top of the device.
4. Plug the charger into a socket.
The LED indicator (4) on the device flashes yellow. The battery is being
charged. The LED indicator (4) on the device flashes green. The battery is
charging. The LED indicator (4) on the device lights up green continuously.
The battery is fully charged.
5. Disconnect the charger from the power supply and the device.
6. Close the charging socket (7) with the cap.
This signal symbol/word indicates a hazard with a
medium level of risk, which, can result in death or
This signal word warns of possible material damage.
Warning!
Fire hazard!
Please note!
5) Cleaning roller
6) Flap for filter unit
7) Charging socket