Operation - Cleanmaxx Zyklon 09271 Gebrauchsanleitung

Operation

CAUTION!
❐ Never hold the nozzles close to parts of your body during use and do not place your
hands inside the nozzles. They could become stuck to the device/injured. If the
vacuum cleaner becomes fi rmly attached due to suction, turn it off immediately (
press down the On / Off switch).
❐ Keep the nozzles away from animals during operation. Never attempt to vacuum
animals using the device. They could become stuck to the device/injured. If the
vacuum cleaner becomes fi rmly attached due to suction, turn it off immediately (
press down the On / Off switch).
❐ Switch on the vacuum cleaner only when you have checked that all parts have been
properly assembled and that the dust container and all fi lters have been inserted
correctly.
❐ To ensure that the cable does not become hot during operation, pull out at least two
thirds of its total length from the device before you switch on the vacuum cleaner. Do
not pull out the cable with force up to its maximum length (not further than the red
marking on the cable) in order to prevent damage!
❐ Always switch the device off fi rst and remove the mains plug from the mains socket
before replacing a nozzle or attaching or removing any accessories.
❐ On no account should the device be used to suck up the following:
– Liquids or wet substances (e.g. wet carpet shampoo)
– Glowing ash, cigarette ends, matches, etc.
– Infl ammable or explosive substances
– Very fi ne dust (e.g. concrete dust), ash or toner
– Pointed, hard objects such as large pieces of broken glass
1. Make sure that the accessories are attached correctly to the device (see the „As-
sembly" chapter).
2. Pull the mains cable out of the unit as far as you require, ideally up to the yellow
marking, but not further than the red marking on the cable!
3. Insert the mains plug into a properly installed mains socket that is easily accessible.
4. Press the
5. Guide the nozzle over the surface to be cleaned. The vacuum cleaner can be pulled
along like a sledge during cleaning.
6. Press the
switch off the vacuum cleaner.
7. Pull the mains plug out of the socket, hold the mains cable fi rmly and using your foot,
depress the
„whiplash" effect of the cable, e.g. against your legs.
8. Once you have used the fl oor nozzle, hook it into the bracket on the back of the device.
9. To ensure optimum performance of the device, you should empty the dust container and
clean all dust fi lters regularly (see the „Cleaning the Device" chapter) after every use.
09271_DE-GB-FR-NL_V1_1.indb 25 09271_DE-GB-FR-NL_V1_1.indb 25
On/Off switch down to switch on the vacuum cleaner.
On/Off switch down again after you have fi nished vacuum cleaning to
button to retract the cable. Holding the mains cable prevents any
25
17.04.2014 11:34:56 17.04.2014 11:34:56