tell Gate Control PRO 20 Schnellinstallationsanweisung Für Installateure Seite 8

Quick setup wizard:
The quick setup wizard will guide you through the essential settings and helps
you to get the device up and running quickly. The wizard starts automatically
if you connect a device with blank settings (e.g., a new device that has not been
configured yet, or after performing a factory reset). However, you can start
the wizard any time by clicking on the Quick setup wizard
Connection type menu.
PIN code, APN and Cloud:
The mobile app and remote access work through cloud service. You can enable
or disable Cloud usage in the General settings menu (enabled by default).
The device attempts to set the APN automatically from the provider. If this fails
(the device does not get an IP address), configure the APN manually in the
General settings menu (the APN is available on the provider's website).
When left blank, the device will use automatic APN setting (restarting the device
is necessary after changing the APN settings). You can check the IP address in
the Status monitoring menu.
If you want to lock the SIM card with a PIN code, enter the PIN code of the SIM
card in the SIM settings section, and enable PIN code request on the SIM card.
In case of using a SIM card that uses a private APN, accessing the cloud server
IP address in the given APN must be specifically enabled at the mobile service
provider. The cloud contact details are the following:
Server address: 54.75.242.103
Registering the super administrator and configuring remote access:
The default settings include a hidden default superadmin user which can be used
to connect to the device remotely over the cloud until a new user is registered
with Super admin or Admin role, and with a remote access password. If there
is at least one remote access password added, the default superadmin access
will be disabled automatically, and will no longer work. The default superadmin
provides full access to remote programming.
Security warning! If you delete all remote access password records, the default
superadmin user will be reenabled automatically, and can again be used to
connect to the device remotely! The purpose of this is preventing you from
locking yourself out from remote access.
The default superadmin credentials are:
Username:
Password:
superadmin
password
Server port: 2016
8
button in the