tell Gate Control PRO 20 Schnellinstallationsanweisung Für Installateure Seite 15

Gate Control PRO - DIN rail – Quick Guide
SAFETY INSTRUCTIONS
For your safety, please read carefully and follow the instructions below!
Failure to observe safety instructions may be a threat to you and your
environment!
TELL's product (hereinafter referred to as „device") has a built-in mobile
communication modem. The built-in modem is capable of 4G and 2G
mobile communication.
 DO NOT USE the device in an environment where radio frequency radiation
can cause a risk and may interfere with other devices that may cause
undesired operation - such as medical devices!
 DO NOT USE the device if there is a risk of high humidity, hazardous
chemicals, or other physical impact!
 DO NOT USE the device beyond the specified operating temperature range!
 DO NOT MOUNT the device in a hazardous environment!
 DO NOT INSTALL/WIRE the device under voltage. For easy disconnection,
the device's power adapter or power supply should be easily accessible!
 ALWAYS DISCONNECT the power supply before starting to mount the
device!
 ALWAYS DISCONNECT the device's power supply before inserting,
removing, or replacing the SIM card!
 TO SWITCH OFF the device, disconnect all power sources, including the
power supply and USB!
 The computer connected to the device must always be connected to the
protective ground!
 DO NOT USE a computer to program the device that is not connected to the
protective ground. To avoid a ground loop, the power supply of the computer
and the device must use the same grounding!
 DO NOT ATTEMPT to repair the device. Only qualified personnel are allowed
to repair the device!
 PROVIDE APPROPRIATE POWER SOURCE for the device. The device
operates safely and properly only with a power supply which meets even the
maximal requirements specified in the user's manual. You can find the exact
data in the user's manual and on the
 DO NOT USE the device with a power supply that does not meet the MSZ
EN 60950-1 standard!
 DO NOT REVERSE THE POLARITY of the power supply! Wire the power
supply always according to the polarity indicated on the device!
http://tell.hu website as well.
15