Archive Setup - Samsung SCR-3000N Bedienungsanleitung

DIGITAL VIDEO RECORDER
4

ARCHIVE SETUP

The following illustration shows the initial settings of the ARCHIVE SETUP menu.
(1) TAPE REC IF HDD TROUBLE
1) EMG
Set whether to allow the VCR to continue the recording if the hard drive fails for some rea-
son. If there is a problem in HDD, it will automatically execute VCR BACKUP. If you
replace the failed hard drive with a new one, VCR backup will be cancelled and the system
will to the previous state, before the failure occurred. [O/X]
2) FULL
Set whether to allow the VCR to continue the recording if DISK END MODE is set to
STOP. However, if DISK END MODE is set to OVERWRITE, this will be disabled.
[O/X]
(2) VCR SPEED
Set the recording mode for the VCR. If you set this to SP, recording time will be shorter
but picture quality will be better than setting it to SLP; and if you set this to SLP, record-
ing time will be longer but picture quality will be poorer than setting it to SP.
SCR-3000N/SSC-Dual [SP/SLP]
SCR-3000P [SP/LP]
Note
Note
- Recording Time to Recording Mode
SCR-3000N/SSC-Dual (NTSC, based on T-120)
SCR-3000P (PAL, based on E-180)
5-11
ARCHIVE SETUP
TAPE REC IF HDD TROUBLE EMG [O]
FULL[X]
VCR SPEED SP
TAPE SELECT T-120
VCR BUZZER OFF
CHANNEL SELECT
CH 1:ON CH 5:ON CH 9:ON CH13:ON
CH 2:ON CH 6:ON CH10:ON CH14:ON
CH 3:ON CH 7:ON CH11:ON CH15:ON
CH 4:ON CH 8:ON CH12:ON CH16:ON
MOVE=[ / ❷ ] SELECT=[ ] EXIT=[MENU]
SP SLP
2 Hours 6 Hours
SP LP
3 Hours 6 Hours
(3) TAPE SELECT
Set the tape length for accurate calculation of remaining tape time and precise control.
SCR-3000N/SSC-Dual [T-120/T-160/T180]
SCR-3000P [E-180/E-210/E-260]
(4) VCR BUZZER
Set the buzzer so that the VCR's status could be known. If there is a problem in VCR SYS-
TEM Set it to ON to enable the BUZZER and to OFF to disable the BUZZER.
The buzzer will sound in the following cases.:
- If there is a problem in the VCR SYSTEM.
- If the tape reaches the end part or is in PRE END (when the remaining time is less than 5
minutes) during ARCHIVE.
- If there is no tape inserted, or REC Safety TAB is removed from the inserted tape when
you start ARCHIVE, or in TIMER ARCHIVE MODE. [ON/OFF]
(5) CHANNEL
CHANNEL is enabled if MULTIPLEXER is set to WITH and disabled if it is set to WITH-
OUT. If CHANNEL is enabled and you set it to SELECT, all channels recorded on the hard
drive will be displayed. If you set it to ALL, all channels will be set to ON and become tar-
gets for backup. [SELECT/ALL]
5-12