Booting The System; Power Off - Samsung SCR-3000N Bedienungsanleitung

DIGITAL VIDEO RECORDER
1

Booting the System

Power On
There is a power switch on the upper right hand side behind the system. Pull the power
switch up to boot the system. Then, the POWER LED (
turned on, a blue screen with the following message will appear and the system is booted.
When booting is finished, the following Live screen will appear.
3-1
POWER
) on front of the system is
LOAD CONFIGURATION...
2003-06-01 12:00:00
Recognizing incoming video signal
The SCR-3000N/SSC-Dual system only recognizes NTSC signal inputs only when booting. The
system will not recognize PAL signals, and a disrupted output would result in a PAL signal were
connected to the system's input. When this occurs, power-down the system and connect an NTSC
signal to the input. The system then initializes to NTSC signals on power-up. On the other hand, the
SCR-3000P system only recognizes PAL signal inputs. Please connect the video signals appropriate
for each model.
If no HDD is installed or if the system is turned on while the hard drive rack is unlocked, the system
will boot up and the Live screen will appear, but the system will not be able to find the HDD. As
shown below, the HDD icon ( ), will not appear.
2003-06-01 12:00:00

Power Off

Push the power switch down in order to turn off the system.
When the system power is turned off during recording, recording will be resumed next time the
system power is turned on and booting is complete.
3-2