PRIXTON RUN FIT RF350 Bedienungsanleitung Seite 15

TOOL KIT
ASSEMBLY INSTRUCTIONS
2 easy steps to assemble your treadmill then you're ready to workout.
Step 1
It is recommended to have a second person assist with this step. One person should hold
the Left/Right Handlebar Support Tubes in place while the other person tightens the
bolts.
Use two (S1)and two (S2) to secure both Left/Right Handlebar Support Tubes onto
the Base Frame. Same operation for installation on the left and right.
Step 2
Slide the Handlebar onto the both Left/Right Handlebar Support Tubes . Secure the
Handlebar onto the both Left/Right Handlebar Support Tubes with two (S2) and two (S3).
IMPORTANT: While sliding the Handlebar onto the both Left/Right Handlebar Support
Tubes , make sure the cables are installed inside the Right Handlebar Support Tube and
pay attention not to pinch the cables.
LUBRICATION
Lubricating your treadmill running belt will ensure superior performance and extend its
life expectan-cy. When you receive your treadmill please apply some lubricant into each oil
cap. After the first 25 hours of use ( or 2-3 months ) apply some lubricant and repeat for
every following 50 hours of use ( or 5-8 months).Run on the treadmill at a slow speed for 3
to 5 minutes to evenly distribute lubricant.
How to check running belt for proper lubrication
Lift one side of the running belt and feel the top surface of the running deck.
If the surface is slick to the touch, then no further lubrication is required.
If the surface is dry to the touch, aplly some lubricant.
Avoid over oiling the running deck.
1. Stop the belt so that the seam is facing upwards and in the centre of the deck.
2. Remove the cap on the oil system.
6#Allen Key x 1
15
Safety Key x 1