Create Wind Clear Rattan Bedienungsanleitung Seite 12

HA NG IN G TH E FAN
1. Place the downpipe with the suspension ball into the mounting bracket, rotate the motor
assembly until the check tab on the mounting bracket has fallen into the registration groo-
ve of the suspension ball and is firmly seated.
Grounding
L
N
2. Make the connection between the wires of the receiver and the wires of the fan motor
according to the colour indications. Make sure that the connection is tight.
3. Insert the remote control controller into the moun-
ting bracket as shown in the picture.
4. Lift the rosette up to the ceiling to cover the mounting bracket (make sure the rosette sits
on the two screws of the bracket), turn the rosette to make sure the head of the screw is at
the end of the holes and finally tighten the screws until it is securely fastened. Then lift up
the magnetised decorative cover to cover the screws on the rosette.
E NGL I SH
12
Input L
(black)
Receiver
remote control
Input N
(white)
Grounding (green / yellow)
Light N (white)
Light L (blue)
DC Motor L (yellow)
DC Motor L (blue)
DC Motor L (white)
Decorative cover