Create Wind Balance Bedienungsanleitung Seite 11

C HOICE OF MOUNT I NG T YPE
Traditional assembly
The traditional setup hangs from the ceiling
with a rod.
This fan can be installed on both a regular and vaulted ceiling, and can extend the hanging
length with the longer hanging rod (supplied). To install the hanger bar you will need the
following tools: a screwdriver, flat head screwdriver, adjustable pliers or wrench, stepladder,
wire cutters, and electrical tape.
MOU NT IN G THE FAN B L ADE S
Before mounting the fan on the mounting bracket, separate the motor parts for mounting the
fan blades by unscrewing the three upper screws on the motor cover.
Align the holes in the blades with the holes in the motor. Tighten the screws securely once
all blades are installed.
Once the blades are installed, reassemble the motor: Replace the motor cover, install the
rubber gasket and tighten the 3 screws to finish.
Angle mounting
Angle mounting is recommended on sloped
or vaulted ceilings.
Screws
Rubber gasket
Motor cover
Motor
E NGLI SH
11