INTERSPIRO INCURVE-E Benutzerhandbuch Seite 9

Close the lever on the buckle. Make sure that the locking tab has locked the lever
4.
in the closed position. (To release the cylinder buckle the locking tab must be
pressed down.) [Fig. 2]
TWIN CYLINDERS
ATTENTION! WHEN OPERATING WITH TWO SEPARATE INDEPENDENTLY-VALVED CYLINDERS, BOTH CYLINDERS MUST
BE CHARGED WITH SIMILAR WORKING PRESSURES. ALWAYS OPEN BOTH CYLINDER VALVES WHEN PRESSURIZING
THE BREATHING APPARATUS AND ENSURE THAT BOTH CYLINDER VALVES ARE KEPT OPEN DURING THE USE OF THE
APPARATUS.
If previously used for single cylinder start by disengaging the cylinder strap from
1.
the four lugs on the backplate. [Fig. 3]
Check that the cylinder strap is positioned with the buckle as close to the
2.
backplate as possible.
If applicable, mount the strap holder and the cylinder distance piece. [Fig. 4]
3.
Check the connection O-ring and screw the T-piece to the cylinder connection of
4.
the manifold block - Do not tighten. [Fig. 5]
Place the cylinders on the backplate with the strap holder between the cylinders.
5.
Check that the hoses are positioned between the cylinders and not squeezed
between the cylinders and backplate. [Fig. 6]
Check the connection O-rings and screw the cylinder valves hand tight to the
6.
cylinder connections of the T-piece.
Tighten the T-piece to the manifold block by hand.
7.
Fasten the cylinder strap buckle around the cylinders and hook together with the
8.
buckle. Adjust the length of the strap if needed. Do not over tighten. If the strap is
over tightened the buckle and backplate will be damaged.
Close the lever of the buckle. Make sure that the locking tab has locked the lever
9.
in the closed position. (To release the cylinder buckle the locking tab must be
pressed down.) [Fig. 2]
CYLINDER PACK
Mounting
Place the cylinder pack on a flat surface with the cylinder valve towards you.
1.
Check the connection O-ring and screw the cylinder valve hand-tight to the
2.
cylinder connection of the manifold block. [Fig. 7]
NOTE! FOR CYLINDER QUICK COUPLING SEE SECTION CYLINDER QUICK COUPLING OPTION.
Fit the holes of the cylinder bracket onto the guide washers and push the
3.
backplate away from you until the harness clicks in position [Fig. 8]. Check that
the cylinder pack is mounted properly by lifting the harness carefully in the upper
and lower part of the backplate.
Dismounting
Unscrew the cylinder connection of the manifold block from the cylinder valve.
1.
9