INTERSPIRO INCURVE-E Benutzerhandbuch Seite 13

PERFORMING THE "FULL TEST"
Open the cylinder valve fully. The display reads according to the figure below.
1.
INTERSPIRO
Check the sound.
2.
CHECK SOUND
Press the backlight button (section 7, Fig. 7-A) during the three seconds that the
3.
display reads according to the figure below.
FULL TEST
HOLD BLACK
The display reads according to the figure below for two seconds.
4.
FULL TEST
NOTE! IF THE CYLINDER PRESSURE IS BELOW THE MINIMUM LEVEL ACCORDING TO THE SETTINGS THERE IS A WARNING
INDICATION. THE TEST CAN BE CANCELED AT ANY TIME BY PRESSING THE RED BUTTON. THE TEST WILL IN THIS CASE
SWITCH TO SHORT TEST.
Check the yellow and red LEDs (section 7, Fig. 7-A) on the display and the yellow
5.
and red BAC-light. If applicable check green, yellow and red LEDs on the HUD.
CHECK
LEDs
Close the cylinder valve and press the backlight button. Make sure to completely
6.
close the cylinder valve before pressing the backlight button.
CLOSE CYL
PRESS BLACK
13