InoTec CLS 24.1 - Power Montageanleitung Und Bedienungsanleitung Seite 43

CLS 24.1/SV Montage- und Betriebsanleitung
Die Einstellungen werden anschließend gespeichert und
das Modul führt einen automatischen Neustart durch,
um die Änderungen zu aktivieren. In dieser Zeit darf kein
manueller Reset durchgeführt werden!
NET+WORKS Version 6.0
Copyright (c) 2003, NETsilicon, Inc.
PLATFORM: connectme_lsk
APPLICATION: INOWeb APP
SetupDialog 1.3
-------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
HARDWARE PARAMETERS:
--------------------------------------------------------------------
APPLIKATIONS PARAMETER:
Neues Password for WEB-Zugriff (max. 9 character)
Benutzername=WEBUSER Password:*******
Aktuelle Ortsangabe: Technical Training 2007
--------------------------------------------------------------------
Press any key in 5 seconds to change these settings.
IP address on LAN is 192.168.100.200
LAN interface's subnet mask is 255.255.255.0
IP address of default gateway to other networks is 192.168.100.201
Serial channels will use a baud rate of 9600
This board's serial number is N99999999
This board's MAC Address is 00:40:9D:27:A0:49
After board is reset, start-up code will wait 5 seconds
Default duplex setting for Ethernet connection: phy Default
CLS 24.1/SV Mounting and Operating Instructions
The settings are then saved and the module restarts
automatically to apply your changes. Do not reset manu-
ally while the module is restarting!
43