nemaxx P6 Bedienungsanleitung Seite 17

ERROR CODES
NOTE: �N THE EVENT OF A POWER FA�LURE (ERROR CODE E7), A SMALL AMOUNT OF SMOKE
MAY BE EM�TTED. TH�S LASTS 3 TO 5 M�NUTES AND DOES NOT REPRESENT A SAFETY R�SK.
CAUT�ON: �F OVERHEAT�NG HAS OCCURRED (ERROR CODES E42 AND E6), THEN AN
�NSPECT�ON,MA�NTENANCE,AND/OR CLEAN�NG MUST OCCUR BEFORE THE STOVE CAN SAFELY
BE OPERATED AGA�N.
After fo��owing the suggested so�ution steps, press the con昀椀rm button
the error code from the mu�ti function disp�ay screen. Then go through the operation procedure
speci昀椀ed on page 15 to restart the heater.
ERROR
CODE
Exhaust temperature is below
40 - 45 °C Operation has been
E1
interrupted and the 昀椀re has been
discontinued
E2
Failure to ignite the fuel in 昀椀re pot.
Low pressure detected at the vacuum
E5
switch (refer to exploded view).
Failure at the high temperature sensor
E6
(located below the pellet hopper).
E7
Power failure.
Short circuit at temperature sensor #1
ESC1
(Exhaust)
ESO1
Open circuit at temperature sensor #1.
Short circuit at sensor #2, hopper
ESC2
temperature
ESO2
Open circuit at temperature sensor #2
Short circuit at room temperature
ESC3
sensor (#3)
ESO3
Open circuit at temperature sensor #3
CAUSE
- Check that the pellet hopper has fuel.
- Check that the auger motor is not damaged and is able to 昀椀ll the 昀椀repot
with fuel
- Check that there are no "clinkers" (glass like lumps of various sizes formed by
debris exposed to high heat, more common when using low quality fuel) in
昀椀re pot.
- Check that the 昀椀re pot is sitting in the holder correctly and that the igniter is
not obstructed.
- Check that the exhaust gas temperature sensor switch, beside the com-
bustion fan, is not broken.
- Check that the igniter is not broken.
- Check that the door, and ash drawer if present, has been closed properly.
- Check that there is nothing obstructing the exhaust duct nor that the duct is
leaking.
- Check that the combustion fan is not broken.
- Let stove cool down and clean the stove thoroughly before restarting.
- Check that the switch is not broken.
- If code persists or continues to reoccur, please halt Operation of the stove
and call customer service.
Press the Con昀椀rm button to clear the error code. Then restart the stove. You
may chose to skip directly into the stabilization cycle by depressing and
holding the rate selector button for 3 seconds.
- Check wires and connection points.
- Contact Tech Support for assistance.
- Check wires and connection points.
- Contact Tech Support for assistance.
- Check wires and connection points.
- Contact Tech Support for assistance.
- Check wires and connection points.
- Contact Tech Support for assistance.
- Check wires and connection points.
- Contact Tech Support for assistance.
- Check wires and connection points.
- Contact Tech Support for assistance.
to c�ear the error code from
SOLUTION
EN
17