nemaxx P6 Bedienungsanleitung Seite 10

2. Basic Parameters of WIFI Module
Parameters
Network frequency
Standards of WIFI
Protocol stack support
Security support
Network type support
3. P�ug the W�F� modu�e correct�y into the
disp�ay PCB and then press the Connect
button for 3 seconds unti� the indicator �ight
turns on.
ACTIVE THE WIFI FUNCTION
Figure 19a Mounted Multi-Function Controls Panel
1. Press the button
2. Enter the password „1088" by pressing the
button .
3. Press the button
the next number.
4. Press to entry the setting.
Details
2.412 ~ 2.48 GHz
IEEE 802.11 b/g/n
(channels 1-14)
TCP/IP
WPA/WPA2
STA/AP/STA+AP
Up
Time Down
for 3 seconds.
to move the number onto
5. Press to se�ect W�F� mode
6. Press to turn it "on"
7. Press to save the settings
8. Press to exit the settings
SMART STOVE WIFI CONNECTION
This stove can be monitored, contro��ed, and
programmed by using the smart stove app by
Smart Stove which is avai�ab�e for iOS or
android device through the app store.
1. Down�oad the Smart Stove app by Smart
Stove.
2. Open the Smart Stove app. The app opens,
by defau�t, to the "Register" screen. C�ick
on the "Register" button.
3. Enter your emai� address in the "Emai�"
昀椀e�d and c�ick the "Get Veri昀椀cation Code"
button.
4. Enter the veri昀椀cation code that was emai�ed
to you in the "Enter Veri昀椀cation Code" 昀椀e�d.
5. Now you can set a unique password for
your device in the "Set Password" 昀椀e�d and
hit the "Done" button.
6. �f you have no other wi昀椀 enab�ed devices
a�ready added to this app there wi�� be a
�arge "Add Device" button in the center of
the screen which you can se�ect.
Otherwise, se�ect the + symbo� in the top
right of the screen.
7. Make sure that your device is connected to
the wi昀椀 network which you want the stove
to be connected to.
8. Make sure that the wood pe��et 昀椀re stove is
p�ugged into an e�ectrica� out�et and fo��ow
the directions on the screen by pressing
and ho�ding the connection button for 3
seconds on the rear of the disp�ay pane� as
i��ustrated in the 昀椀gure be�ow. Once you
observe the desired b�inking pattern on the
indicator �ight, press the con昀椀rmation button
at the bottom of the screen.
9. Enter the password for the wi昀椀 network so
that the stove can connect to the wi昀椀
network.
10. The stove wi�� begin pairing with the device
running the app�ication through the wi昀椀
network. This process may take a few
minutes.
EN
10