AL-KO Robolinho 2300 W Betriebsanleitung Seite 50

GB
Malfunc- Cause
tion
Appliance vibrates or the volume is too high.
Imbalance on the cutting blade or in
the cutting blade drive
Rechargeable battery cannot be charged or low battery voltage
■
The charging contacts of the base
station are soiled.
■
The contact surfaces on the appli-
ance are soiled.
■
Base station has no power.
■
The appliance does not touch the
charging contacts.
■
The service life of the battery has
expired.
■
The charging electronics are
faulty.
Display fails.
No correct display on the display
10.2 Fault codes and troubleshooting
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Error code
CN001: Tilt sensor
CN002: Lift sensor
50
Cause
The tilt sensor has tripped:
■
Max. tilt angle exceeded
■
The appliance has been
carried
■
Slope too steep
The lift sensor has tripped:
■
The appliance cover has
been deflected upwards
by lifting or by an obsta-
cle.
Remedy
■
Clean the mower deck.
■
Contact one of the manufacturer's service
centres.
Clean the charging contacts and contact surfac-
es.
Connect the base station to the power source.
■
Place the appliance in the base station and
check that the charging contacts make con-
tact.
■
Contact one of the manufacturer's service
centres.
Contact one of the manufacturer's service cen-
tres.
Contact one of the manufacturer's service cen-
tres.
1. Stop the device using the STOP button.
2. Turn the device off and on again using the
On/Off button.
3. Acknowledge the error.
The complete list of error
codes can be found at the fol-
lowing address:
https://alko-garden.com/
robolinho-error-codes/
Remedy
Place the appliance on a flat surface
and cancel the fault.
Remove the obstacle.
Help in case of malfunction
Robolinho