Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
After the calibration run
The preset current mowing duration is displayed.
For all further settings, refer to see chapter 7
"Settings", page 45.
5.5
Setting the start points
To ensure proper operation and reduce error
messages, the loop length must be measured
with the Interactive teach function.
Teaching-in start points
1. Place the appliance in the base station.
2. Switch on the appliance with
3. Call up the main menu with
* Programs
4.
or
* Entry Point
5.
or
* Interactive teach
6.
or
* Start interactive entry
7.
or
point teaching
■
Start
or
moves along the boundary cable.
■
Set
or
has reached the required start point. The
start point is stored.
Set entry point 1
8.
or
start point has been specified during the
teaching-in movement. If no start point has
been specified here, the start points are auto-
matically specified.
Entry point x: XXm
9.
or
the last start point has been reached.
Manually specifying start points (05)
The first start point (05/X0) is pre-set and is 1 m
to right of the base station. Other start points can
be defined after this point (see technical data).
When specifying the start points, heed the follow-
ing:
■
Do not set start points too far from the base
station or too close to one another (06/f).
■
Only use as many start points as necessary.
* Entry Point
1.
or
* Point X1 at [020m]
2.
or
Select one digit in sequence with
and always accept with
44
.
.
:
. The appliance
when the appliance
if no
if
or
.
* Point X2 at [075m]
3.
or
Select one digit in sequence with
and always accept with
4. If necessary, specify further start points.
5. Return to the main menu with
6 OPERATION
6.1
Starting the appliance manually
1. Switch on the appliance with
For unscheduled edge mowing: see chapter 7.7
"Edge mowing with a manual start", page 46.
2. Start the appliance manually with
6.2
Cancelling mowing
■
Press
on the base station (12/4) or on the
appliance.
The appliance moves automatically into the base
station. It deletes the mowing plan of the current
day and starts again the next day at the set time.
■
Press
on the appliance.
Mowing is interrupted for half an hour.
■
Press
on the appliance.
The appliance is switched off.
NOTE In dangerous situations, the appli-
ance can be stopped with the STOP but-
ton (12/2).
6.3
Mowing the secondary area (05/NF)
1. Lift the appliance and place in the secondary
area by hand.
2. Switch on the appliance with
3. Call up the main menu with
* Settings
4.
or
* Sub zone mowing
5.
or
6. Select the mowing time with
7. Start the appliance manually with
Depending on the setting: The appliance mows
for the set time period and then switches off or
mows until the rechargeable battery is flat.
After mowing the secondary area, place the ap-
pliance in the base station again by hand.
Operation
or
.
.
.
.
.
.
or
.
.
Robolinho
Werbung
