Scheppach PM1400 Originalbetriebsanleitung Seite 23

h) If the power tool falls into the material to be
mixed, unplug the power tool immediately and
have the power tool checked by a qualified re-
pair person. Reaching into the mixing container
with the power tool still plugged in can lead to elec-
tric shock.
i) Do not reach into the mixing container with
your hands or insert any other objects into it
while mixing. Contact with the stirrer may lead to
serious personal injury.
j) Start up and run down the power tool in the
mixing container only. The stirrer may bend or
spin in an uncontrolled manner.
Residual risks
m The machine has been built according to the state-
of-the-art and the recognised technical safety require-
ments. However, individual residual risks can arise
during operation.
• Danger of injury for fingers and hands due to the ro-
tating stirrer.
• Hazard due to electrical power with the use of im-
proper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety in-
structions" and "Intended use" are observed along
with the complete operating instructions.
6. Technical data
Rated voltage
Power consumption
Idle speed
Stirrer receptacle
Protection class
Weight
Subject to technical modifications!
Noise and vibration
The noise and vibration levels have been determined
in accordance with EN 60745.
230 V~ 50 Hz
1400 W
0-570 min / 0-760 min
-1 -1
M14
II
4.9 kg
www.scheppach.com
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L
WA
Uncertainty K
WA
Wear hearing protection.
Excessive noise can result in a loss of hearing.
Total vibration emission values (vector sum of three
directions) determined according to EN 60745.
Vibration emissions value a
Uncertainty K = 1,5 m/s
2
Additional information for electric tools
Warning!
The specified vibration emission value has been
measured according to a standardised testing proce-
dure and can be used for comparison of one power
tool with another; and may change depending on the
way in which the power tool is used and in exceptional
cases may be higher than the specified value.
The specified vibration emission value can be used to
compare one power tool with another.
The specified vibration emission value can also be
used for an initial estimation of the impair.
Keep the noise level and vibration to a minimum!
• Only use devices which are free of defects.
• Maintain and clean the device at regular intervals.
• Adapt your working methods to the device.
• Do not overload the device.
• Have the device checked if necessary.
• Switch the device off if it is not in use.
• Wear gloves.
7. Unpacking
• Open the packaging and carefully remove the
product.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
89 dB
3 dB
100 dB
3 dB
= 5,673 m/s
2
h
GB | 23