Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mode
Bicycle mode
< 30 psi
Motorcycle
< 2 bar
mode
Car mode
< 2 bar
Ball mode
< 4 psi
Manual mode
10.3 Adjusting the pressure (Fig. 1)
The pressure can also be regulated using the "+" (4)
and "-" (10) buttons.
The "+" button can be used to increase the pressure.
The "-" button can be used to decrease the pressure.
10.4 Inflate (Fig. 1)
• Press the On/Off switch (12) to start the inflation
process.
• The pump stops automatically as soon as the pre-
set pressure is reached.
• It can also be stopped by pressing the On/Off button
(12) again.
• After inflating, first remove the adapter (15, 16, 17)
from the compressed air hose and then pull the com-
pressed air hose (18) off the device.
10.5 LED work lamp (Fig. 1)
This product is equipped with an LED work lamp (1) to
illuminate the immediate work area and improve visibil-
ity in poorly lit environments.
CAUTION! Do not look directly into the LED work lamp
or the light source.
1
Press the LED button (3) again for a short time to
switch the LED work light (1) on.
2
Pressing it again switches the light off.
10.6 Signal lamp
11 Briefly press the signal light button (5) to switch
it on.
12 When pressed again, the signal light flashes fast-
er.
30-50 psi
2-3 bar
2-3 bar
6-16 psi
Continuous
www.scheppach.com
13 Pressing a third time switches the light off again
(the signal light can also be used when the device
is switched off).
10.7 12V connection cable (Fig. 2, 5)
Note: When operating with a 12V DC power source,
the cigarette lighter's fuse must have a value of at least
15 A. If the actual value is less than 15 A, the fuse may
melt. If you have any questions or doubts in this regard,
please contact the vehicle manufacturer. No liability
can be accepted for improper applications.
To supply the product with power via the connection
cable (12V DC) (14), connect the cable to the port (9)
on the device and to a 12V DC power source (cigarette
lighter).
11. Cleaning and maintenance
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth or blow it off with
compressed air at low pressure.
• We recommend that you clean the product directly
after every use.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the product. Make sure that no water can
penetrate the interior of the product. Water penetra-
tion increases the risk of an electric shock.
• The interior of the product has no further internal
parts that require maintenance.
12. Repair & ordering spare parts
After repairs or maintenance, make sure that all safe-
ty-related parts are installed and are in perfect con-
dition. All parts which may cause injury must be kept
where they are inaccessible to children or others.
Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by im-
proper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
GB | 27
Werbung
