Parkside Performance PPFSA 40-Li B3 Originalbetriebsanleitung Seite 44

GB MT
ways keep the device at a suitable
safety distance from the body and
maintain a stable body posture.
3. Always wear safety goggles.
4. Only use the device in daylight or
where there is good artificial light-
ing.
5. Do not use the device in the rain or
on wet grass.
6. Check the device for damage be-
fore use or after an impact, and re-
pair if necessary.
7. Do not use the device if the safety
equipment is damaged or incor-
rectly installed.
8. Ensure that the ventilation slits on
the engine, the protective cover
and cutting unit are always free of
dirt or residual material.
9. During the work process, always
ensure that there are no people or
animals within a radius of at least
15 m. Switch off the device imme-
diately if anyone, especially chil-
dren, comes within reach of the
machine. When using the device,
stones and other objects can be
ejected, which may lead to seri-
ous injuries.
10. When the device is in operation,
do not get near to the moving
parts (within the cutting unit area).
The cutting head will keep rotat-
ing for a few seconds after the
device has been switched off.
11. Before using the device, stones,
twigs and any other solid materi-
al must be removed from the work
area. Only start the machine as
described in the manual. It must
not be upside down when starting
or in the working position. Do not
cross any gravel roads or paths
with the device running.
12. Extreme caution is required when
extending the cutting line. There is
44
a risk of cutting injuries. After per-
forming these steps, the device
must be brought back into the cor-
rect working position before being
re-started.
13. Do not use any metallic cutting
spools. Note that the device will
continue to operate for a few
seconds after you let go of the
switch.
14. Switch off the engine when:
• you are not using the device,
• leaving it unattended,
• cleaning it,
• transporting it from one location
to another,
• Removing or replacing the cut-
ting unit or adjusting the length
of the cutting line by hand.
15. Prolonged use of the device can
lead to hearing damage if appro-
priate hearing protection is not
worn. Wear personal hearing
protection, e.g. ear plugs, to re-
duce the risk of hearing damage.
16. Prolonged use of this motorised
device can lead to problems with
the blood circulation in the hands
caused by vibrations (Raynaud's
syndrome). However, you can ex-
tend the duration of use by wear-
ing suitable gloves or taking reg-
ular breaks. Please ensure that if
you are susceptible to poor circu-
lation, low outside temperatures or
strong gripping forces while work-
ing, this may reduce the length
of time for which you are able to
work.
17. Carry the device by the upper
and lower shaft tube when it is
switched off, with the cutting unit
pointing away from your body
in order to avoid injuries. After
switching off, the motor head of
the device is hot. Make sure that