15 Dot3Ad; Link-Aggregation; Link-Aggregation Add; Link-Aggregation Modify - Hirschmann Rm Cli Hios-2S Rsps Referenzhandbuch

Dot3ad

15 Dot3ad

15.1

link-aggregation

Configure 802.3ad link aggregation parameters to increase bandwidth and
provide redundancy by combining connections.
15.1.1

link-aggregation add

Create a new Link Aggregation Group to increase bandwidth and provide link
redundancy. If desired, enter a name up to 15 alphanumeric characters in
length.

Mode: Global Config Mode

Privilege Level: Operator

Format: link-aggregation add <P-1>
Parameter Value
lag/<lagport>
P-1
15.1.2

link-aggregation modify

Modify the parameters for the specified Link Aggregation Group.

Mode: Global Config Mode

Privilege Level: Operator

Format: link-aggregation modify <P-1> name <P-2> addport
<P-3> deleteport <P-4> adminmode linktrap static min-
links <P-5>
name: Modify the name of the specified Link Aggregation Group.
addport: Add the specified port to the Link Aggregation Group.
deleteport: Delete the specified port from the Link Aggregation Group.
adminmode: Modify the administration mode of the specified Link Aggrega-
tion Group. To activate the group, enable the administration mode.
linktrap: Enable/Disable link trap notifications for the specified Link Agg-
regation Group
static: Enable or disable static capability for the specified Link Aggregation
Group on a device. When enabled, LACP automatically helps prevent loops
and allows non-link aggregation partners to support LACP.
min-links: Set the minimum links for the specified Link Aggregation
Group.
146
Meaning
lag/<lagport> Enter a lag interface in
lag/lagport format.
15.1 link-aggregation
RM CLI HiOS-2S RSPS
Release 3.0 01/2014