Werbung
3
Innerglasspanel
2
Outerglasspanel
3
Plasticglasspanelslot-Lower
As illustrated in figure,raisetheinnermost g lasspanel
I
sli htl
in direction A and
When installing the inner glass panel (1), make sure
that the printed side of the panelfaces towards the
inner.
It is important to seat lower corner of inner glass panel
into the lower plastic slot.
Pushthe plasticparttowardstheframeuntilyouhear
a "click".
Replacin the oven lamp
DANGER:
Beforereplacingthe ovenlamp,makesure
hat the product is disconnected from mains
and cooled down in order to avoid the risk of
an electrical shock.
Hotsurfacesmay causeburns!
22/EN
1
2
ull it out in direction B
Theovenlampis a specialelectriclight bulb
hat can resist up to 300 oc. See Technical
specifications, p age 11 for details.Ovenlamps
can be obtained from Authorised Service
Agents or technician with licence.
Position of lamp mightvary from the figure.
i
Thelampusedin this applianceis not suitable
i
or household room illumination. The intended
purposeof this ampis to assistthe userto
see foodstuffs.
The lamps used in this appliance have to
withstand extreme physical conditions such as
emperatures above50 oc.
If your oven is equipped with a round lamp:
1.
Disconnect the product f rom mains.
2.
Tum theglasscovercounterclockwise to remove
it.
3.
Ifyourovenlampis of type(A)shownin thefigure
below, remove it by rotating as shown and replace
it. If it is of type(B),pull andremoveit as shown
in the figure and replace it.
4.
Install the glass cover.
O
Werbung
