ARGENTO Performance Pro Bedienungsanleitung Seite 30

Malfunction indicator light
If a malfunction of the bike's electrical and/or electronic system is detected, the relevant warning light will appear on the
display screen and the corresponding identification Error Code will be displayed at the same time.
Error Code
04
06
07
08
09
10
11
12
13
14
21
22
30
Parameter configuration
Press the M button for at least 2 seconds to access the configuration menu and then, quickly press the M button to confirm
the data entered and display the next parameter to be configured.
Select the desired value for the individual parameter by pressing the + or - buttons and confirm it by pressing the M button
(quickly to access the next parameter or for at least 2 seconds to exit the configuration menu).
The sequence of parameters that can be configured is shown below:
S7 - Unit of measurement:
press the + or – buttons to select the unit of measurement for the speed and distance data shown on the display:
international metric system (Km/h and Km) or British imperial system (MPH and Mile) B1 - Backlight:
press the + or – buttons to change the illumination level of the display screen (selectable values between 1 and 5).
0FF - Automatic shut-down:
press the + or – buttons to set the minutes before the display is automatically switched off (selectable values between 1 and
15).
The function can be disabled by selecting 0.
Hd - System parameter:
Pre-defined value = 28
CAUTION
If faulty data for speed and distance are shown on the display, reset the correct value indicated by using the + or - buttons.
Pd - Password:
enter the password "1919" using the + or - buttons and confirming each digit by pressing the M button to configure the
additional use parameters.
SL - Speed limiter:
press the + or – buttons to increase or lower the set speed limit (selectable values between 10 and 100).
Malfunction description
Accelerator malfunction
Low voltage protection (voltage below threshold)
High voltage protection (voltage above threshold)
Motor hall sensor malfunction
Motor phase line malfunction
Control unit overheated
Motor overheated
Current sensor malfunction
Battery overheated
Motor malfunction
Speed sensor malfunction
BMS malfunction
Communication malfunction
29